The love series jewelry is the classic series of Cartier, and the love bracelet is deeply loved by consumers worldwide for its unique design. So, how to choose the size of Cartier love bracelet?

  Cartier Love bracelet common number is basically 16-22, basically the inner circumference minus 1 is the number of centimeters of the inner circumference, for example, the -1 of 20, the inner circumference is 19CM. cartier love bracelet size measurement there are two main methods.

First, choose a bracelet that is suitable for your hand size

Place your daily bracelet flat and take a measuring tape to measure the circumference of the bracelet. Note down the size of the bracelet. Choose a Cartier bracelet size that is closest to this size. the Love bracelet size differs slightly from the usual standard, please refer to the Love bracelet size chart bracelet section, CChen Jewelry recommends that you add 1 cm to this size to achieve a tighter fit and 2 cm to achieve a comfortable fit.

Second, use the Cartier bracelet size comparison table

IMPRESSION OPTION

To get the best results, you will need to go to the ‘printing option’ before printing and ensure that the ‘page scaling’ option is set to ‘none’ in the print dialogue box. The Cartier Wrist Sizer must be printed on a full letter size (8 ½ x 11 inches) size page. To check that the Wrist Sizer has been printed properly, take a ruler and measure the sample below. It should measure exactly 2 cm.

HOW TO USE THE CARTIER WRIST SIZER

  • Cut out the paper Wrist Sizer and follow the instructions below.
  • Make sure that the numbers are on the outside of the paper Wrist Sizer and insert the pointed end through the opening you have cut at the the other end of the Wrist Sizer where indicated [cut here]. Place your hand through the Wrist Sizer and pull the pointed end until it fits comfortably on your wrist.
  • The number that lines up with the edges of the opening is the size of the wrist.
  • You can also use a tape measure but if you do not have one, take any small piece of ribbon or cord. Wrap it around your wrist and measure the length against a ruler.

CHOOSING THE SIZE OF A LOVE BRACELET:

The usual bracelet sizing rules differ slightly in this case due to the design of the LOVE bracelet. Once you have found your size in the Bracelet Sizing Chart, Cartier recommends adding one centimeter for a tight fit and two centimeters for a loose fit.

1, Cut out the paper wrist size gauge and measure your wrist as described below.

  2, Make sure the number is on the outside of the wrist size gauge and insert the sharp corner of your cut end into the other end of the wrist size gauge labeled [cut here]. With the wrist size gauge on, pull out the sharp corner until your wrist feels comfortable.

  3. The number on the edge of the opening is for the Cartier bracelet size. Cartier bracelet size is 12-23MM, choose according to the measured size when you buy.

  4, you can also use a tape measure, prepare a tape measure, around the wrist a circle, in order to wear comfortable, on the basis of the wrist circumference increased by 1.5 cm, and then based on comfortable, just right, tighter three wear standards to increase or reduce the size.

  Note: The Cartier bracelet size comparison table is for reference only and may not be accurate. You can go to a Cartier boutique to get a special measurement.

  Cartier love bracelet size

  The Love bracelet size differs slightly from the usual standard, please refer to the Love hand size chart bracelet section. Cartier recommends that you add 1 cm to this size to reach the tighter wearing standard and 2 cm to reach the comfortable wearing standard.

Bracelet size comparison table and measurement method

Method 1.

In the measurement, the 4 long fingers (except the thumb) and to the “tiger mouth”, squeeze some, and then the measurement tool to measure, for example, just 45 mm, then, on the basis of this plus 2 ~ 3mm is suitable for your ring mouth. This specification will have a certain pain when wearing, please use hand sanitizer and other lubrication Ji lubrication can be. Some people like to wear a little looser, you can choose a slightly larger ring.

Method 2.

When you choose to wear jade bracelet, you should be able to wear the jade bracelet into the four long fingers (except the thumb) and to the “tiger’s mouth”, feel slightly tighter, and then take the jade bracelet off, measure the inner diameter, for example, just 55 mm, then this size is suitable for your circle mouth. Some people like to wear a little looser, when choosing, choose the circle mouth 1 to 2 mm larger, so it will be easier to put on and take off. There are also some people who are used to wearing smaller jade bracelets, or put them on and do not intend to take them off again, in this case, you can in turn reduce the size of 1 to 2 mm. In general, when choosing, you should try it on first. When trying on, you can apply some detergent or soapy water on your hands, and ask someone to help, with a little force to wear the jade bracelet into the wrist.

Method 3.

With your fingers together, ask someone to help you measure the circumference of the thickest part of your hand in the thinnest state with a soft rope and divide by 3.14, then add 1~2mm that is the inner diameter of the bracelet that fits you. For example: your measured length is 170mm, then 170/3.14 1~2=55~56mm.

Method 4.

Use a straightedge (soft ruler) to measure the width of your hand at the width of your palm (except your thumb). The measured size according to the following corresponding data, choose the appropriate inner diameter size of the bracelet. The widest part of the palm.

62 – 66MM : with the inner diameter of 50 – 52MM bracelet

66–70MM: with the inner diameter of 52-54MM bracelet (the following chart)

70–74MM: with inner diameter 54–56MM bracelet

74–78MM : with inner diameter 56–58MM bracelet

78–82MM : with inner diameter 58–60MM bracelet

82MM or more: with an inner diameter of 60MM or more bangles

Attention.

The above four methods, each with shortcomings, you’d better try each method as much as possible, more than a few measurements and then seek the average. This is more accurate. Even if you measure out the same size size, but also due to the softness of each hand bone and age and different, hands of manual labor to do more people generally hand bones and meat will be stronger, the size of the corresponding to relax some, older than the general age of the hand bone hard, and vice versa.